Abus TVVR70020 User Manual download pdf (Page 32)

Actions

Commands

Here you can set up up to 3 commands for each camera.

The following commands are available:

- Go to preset

- Start tour

- IP Relais

Under the “Event” menu item, you can set when a

command is to be triggered.

Pos.

Meaning

Select a camera in

preview bar

Tick the “1. Activate Command” checkbox

Select “IP MD”, “IP Input” or “Camera separately”

Under the “Command” menu item, you can set which

type of command is to be executed.

Pos.

Meaning

Select “PTZ-Position”, “PTZ Tour”, “Relay Level”

or “Relay Edge”

Level:

When the relay contact is used with level control, the

contact remains closed until opened manually by the

user.

Edge:

When the relay contact is used with edge control, the

contact remains closed until the set hold time has

elapsed.

Under the “Selection” menu item, you can set which

preset is to be used, which tour started, or which relay

switched.

Pos.

Meaning

Select a preset position, a tour or a relay.

To complete your configuration, please click on “Save”.

Example for setting up a command:

Camera 1 is to go to preset position 1 if movement is

detected.

Pos.

Meaning

Select camera 1 in the

preview bar

Tick the “1. Activate Command” checkbox

Select the “IP MD 1” menu item

Select the “PTZ-Position” menu item

Select the “Preset position 1” menu item

Click on “Save”

Now camera 1 will go to preset position 1 if movement is

detected.

Note

To be able to set up this command, you must

have set up movement detection in the camera. In

addition, preset position 1 must be stored.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Comments to this Manuals

No comments

Abus TVVR70020 User Manual Page 32

Comments to this Manuals

Related products and manuals for Security access control systems Abus TVVR70020